Avaya 206 부록 매뉴얼
USER'S CARD
Custom Feature Programming (For FEATURE PACKAGE 1)
Also Refer to USER'S GUIDE Programming Section and Index
●
Assigning Features to Buttons
Activate
●
Enter program mode by sliding T/P switch to P position (ringing)
●
Touch a programmable
button
●
Dial feature code
●
Dial number (if required)
●
Leave program mode by sliding T/P
switch to center position
Feature Codes
AUTO ANSWER
= *70
DO NOT DISTURB
= *71
PRIVACY
= *72
LAST NUMBER
= *73
SAVED NUMBER
= *74
PAGE
= *66
INTERCOM AUTO DIAL
= * 6 + Intercom number
OUTSIDE AUTO DIAL
= *90 + Outside number
Note:
If you want to assign features to more than one programmable button, remain in program mode until finished—there is
no need to go in and out of program mode for each button assignment.
no need to go in and out of program mode for each button assignment.
●
Changing a Number on Outside Auto Dial Button
Outside Auto Dial
●
Enter program mode by sliding switch T/P switch to P position (ringing)
●
Touch Outside Auto
Dial button
●
Enter new telephone number
●
Leave program mode by sliding T/P switch to center
position
Note:
If you want to change more than one Auto Dial button, you can do it in one changing sequence and don't need to go
in and out of program mode for each.
in and out of program mode for each.
●
Programming Special Functions in an Outside Auto Dial Sequence
Pause: Automatic Dialing will
●
Touch HOLD (pause)
pause for 1.5 seconds
Stop: Automatic dialing will stop
●
Touch DROP (stop)
until button is touched again
Flash (or "Switchhook" Flash)
●
Touch RECALL
for PBX, Centrex and Custom
Calling Features
Calling Features
●
Programming Auto Dial for An Additional Long-Distance Service
Outside Auto Dial
●
Enter program mode (ringing]
●
Touch botton to be programmed
●
Dial *90 (if
not already an Auto Dial button)
●
Enter local telephone number (7 digits)
●
Touch DROP (stop)
●
Enter authorization code (usually 5 or 6 digits)
●
Leave program mode
Note:
Use this button for access to the long distance service. Program individual telephone numbers on separate buttons.
●
Programming Automatic Line Selection
To Specify Order of
●
Enter program mode (ringing)
●
Dial two stars **
●
Touch outside line buttons in desired order
Automatic Line Selection
(for no auto line selection omit this step)
●
Dial two stars**
●
Leave program mode
Note:
You may program some, all, or none of your lines for Automatic Line Selection. Also, you must always re-enter program
mode before programming Automatic Line Selection.
mode before programming Automatic Line Selection.
●
Changing Line Ringing on Calls from Outside
Change How or Whether
●
Enter program mode [ringing)
●
Touch outside line button (note red light signals)
●
Repeat
Each Line Rings
touching until desired light code appears:
RED ON
= RING
RED FLASH = DELAYED RING
RED OFF
RED OFF
= NO RING
●
Leave program mode
●
Once
you've completed your programming, remember to label all buttons
MERLIN is a trademark of AT&T
© Copyright 1984 AT&T. Printed in U.S.A.
999-502-135 IS
Issue 3, June 1984