Epson 1915 네트워크 가이드
Connecting to a Projector on a Different Subnet
41
Connecting to a Projector on a Different Subnet
By default, this application only searches for projectors on the same
subnet as the computer. Therefore, even if you perform a search for
projectors on the network, projectors on a different subnet will not be
found.
You can, however, identify and connect to a projector on a different
subnet as follows:
• Specify either an IP address or Projector name and perform a search.
subnet as the computer. Therefore, even if you perform a search for
projectors on the network, projectors on a different subnet will not be
found.
You can, however, identify and connect to a projector on a different
subnet as follows:
• Specify either an IP address or Projector name and perform a search.
The IP Address can be input directly. Also, provided the Projector
name to be connected has been registered on the DNS server, you can
perform a search simply by inputting that Projector name.s
name to be connected has been registered on the DNS server, you can
perform a search simply by inputting that Projector name.s
• Performing a search based on a Profile
Once you have performed a search for a projector on a different subnet
by specifying either an IP Address or a Projector name, you can save
the search as a Profile with an easy-to-remember name, and then use
that Profile whenever you subsequently want to search for a projector
on a different subnet.s
by specifying either an IP Address or a Projector name, you can save
the search as a Profile with an easy-to-remember name, and then use
that Profile whenever you subsequently want to search for a projector
on a different subnet.s
q
If a search fails to find a projector, the most likely causes are as follows.
Proceed as appropriate, depending on the cause of the failure.
• For both Windows and Macintosh
Proceed as appropriate, depending on the cause of the failure.
• For both Windows and Macintosh
If there is no wireless LAN signal or if the signal is weak, check whether
there is anything that could be interfering with the signal.
there is anything that could be interfering with the signal.
• When the optional supplied or optional Wireless LAN unit is installed in
the projector, and Macintosh is connected to a Wireless LAN
Check whether AirPort is set to On. Or, check whether an appropriate
access point has been selected.
access point has been selected.