Epson CX5400 빠른 설정 가이드
1
Set the feeder guard into its two slots at the back of the Stylus CX.
2
Insert the paper support into its two grooves behind the
feeder guard.
feeder guard.
EPSON Stylus
®
CX5400
Start Here
1
Lift up the entire scanner unit.
2
Shake the package of ink cartridges four or five times.
Then remove the cartridges from the package.
Then remove the cartridges from the package.
Caution: You must install all cartridges and leave them installed
for all types of printing. To avoid damaging the Stylus CX, never
move the print head by hand.
for all types of printing. To avoid damaging the Stylus CX, never
move the print head by hand.
3
Lower each cartridge into
its holder as shown.
its holder as shown.
4
Press down on each cartridge
until it is firmly seated.
until it is firmly seated.
Install Ink Cartridges
5
1
Flip the feeder guard forward.
2
Slide out the edge guide.
3
Place a stack of paper against the right side of the feeder,
but don’t push it in. Slide the edge guide against the paper.
but don’t push it in. Slide the edge guide against the paper.
4
Flip the feeder guard back over the stack of paper.
1
Open the scanner lid, as shown.
Remove any packing materials
under the lid.
Remove any packing materials
under the lid.
2
Slide the transportation lock
to the unlocked position.
to the unlocked position.
Caution: Make sure you
unlock the scanner, or it
won’t work.
unlock the scanner, or it
won’t work.
3
Close the scanner lid.
1
Make sure you have all the parts shown here. If any parts are missing,
contact EPSON as described on the back of this sheet.
contact EPSON as described on the back of this sheet.
2
Remove all tape, as shown.
Note: There may be packing materials or tape in different locations.
3
Lift up the entire scanner
unit. If it doesn’t open,
make sure you have
removed all the tape.
unit. If it doesn’t open,
make sure you have
removed all the tape.
4
Peel off the tape from the
ink cartridge holder and
from the top of the printer.
Make sure you don’t leave
any tape inside.
ink cartridge holder and
from the top of the printer.
Make sure you don’t leave
any tape inside.
5
Lower the scanner unit.
Unpack
Unlock
Turn over
1
Plug the Stylus CX into a grounded electrical outlet.
Do not connect the USB cable yet.
Do not connect the USB cable yet.
2
Press and hold the On button until the green light comes on.
Plug In and Turn On
1
2
On
Error
Scan
Reset
Reset all(3sec)
Recall
Save(3sec)
2
4
6
Load Paper
5
Lower the scanner unit.
The Stylus CX begins charging the ink delivery system.
Charging takes about 2 minutes. The green light flashes and the
Stylus CX makes various sounds. Don’t turn it off while the green
light is flashing or you’ll waste ink.
Stylus CX makes various sounds. Don’t turn it off while the green
light is flashing or you’ll waste ink.
continued
Attach the Parts
3
Paper support
USB cable
Software
CD-ROM
CD-ROM
Quick Reference
Guide
EPSON Stylus CX5400
Ink cartridges
Feeder guard
On button
continue
Don’t remove
this sticker yet
this sticker yet
Don’t touch the green part
4046293-00 CPD-16736
Remove tape and
open the output tray
open the output tray