Epson II 제품 데이터시트

ActionLaser II

The optional multi-media feeder handles automatic feeding of many
types of paper. It holds up to 150 

of paper, and it can feed

paper from 98 to 216 mm (3.86 to 8.50 inches) wide and from 148 to
356 mm (5.83 to 14.0 inches) long. You can load two different sizes of
paper in your printer at once (one size in 

multi-media feeder and

other in your standard paper cassette). You can also set SelecType

Level 1 INPUT to AUTO and use both the multi-media feeder and
the standard paper cassette for continuous printing of up to 250
sheets of the same size paper.

Installing the multi-media feeder

1. Remove the manual feed paper guide.

2. Attach the multi-media feeder as shown below. Then, mount the

multi-media feeder safely on the printer.

If an error occurs, your best source of information is the display 

the control panel. The messages displayed there tell 

and, in some cases, indicate the actions you should take to

correct the problem. Status messages appear on the display during
normal operation. They indicate 

printer’s current status.

This section contains 

alphabetical list of status and error messages

you may encounter while printing and includes steps you can take to
correct 

problems.

Note: 

some 

red 

error is

detected. This requires you to correct 

problem and then press

to clear the error. However, if the AUTO CONT option in

SelecType is set to on, some errors may clear automatically even

problem remains. In most instances, you should leave

AUTO CONT set to off.

section, status messages are preceded by [S], error messages

are preceded by [E] and warning messages are preceded by [W]. In
some cases the message you see on your display also shows the
printer mode.

[E] ADD MEMORY FOR U-I-X

This indicates that there is not enough memory in Channel X. See
Chapter 4 for instructions on changing the RX-BUFFER SIZE or
adjusting the memory distribution in the INDIVIDUAL setting or

see Appendix A for adding memory.

[E] CANCEL MANUAL FEED

This message indicates that there is no paper in the manual feed
slot when you are using manual feed. See Chapter 5.

[E] CHANGE PCU XXXXX

Replace the photoconductor unit as described in Chapter 6.
The PCU counter tells you the number of pages that have been
printed.

[S] CHAR CREATING

Characters are being created.

[S] COPY END

Multiple-copy printing is cancelled. (You pressed the 

button when the printer was off line.)

[E] COVER OPEN

The printer or fan cover is open or the toner cartridge or
photoconductor unit is not installed. Close the printer or fan
cover or install the toner cartridge and photoconductor units.

[S] DATA

The printer has received data but is not yet printing or 

printer

has received data and is off line. If the printer is off line, press

to print the data.

[E] FEED JAM

Paper is not feeding into the printer from the specified cassette or
has jammed on its way into the printer. See the FEED JAM section
in this chapter for information.

[S] FONT CREATING

A font is being created.

[S] GRAPHIC DRAWING

Graphics are being drawn.

[E] ILLEGAL CARD

A card in the card slot or a cartridge in 

cartridge slot cannot

be read. To correct this error, take the printer off line and then
press 

If the error 

remains, make sure the

printer is off line and remove the card or 

cartridge. If 

red

light still flashes, press 

[S] INITIALIZE

The printer is being initialized to the factory or optional settings.

Laser Printers

9/17/91

ALll-7