Epson 777 사용자 설명서

Before using your printer, read the following safety instructions to make sure you use the 
printer safely and effectively:

■

Be sure to follow all warnings and instructions marked on the printer.

■

Use only the type of power source indicated on the printer’s label.

■

Connect all equipment to properly grounded power outlets. Avoid using outlets on the 
same circuit as photocopiers or air control systems that regularly switch on and off.

■

Place the printer near a wall outlet where the plug can be easily unplugged.

■

Do not let the power cord become damaged or frayed.

■

If you use an extension cord with the printer, make sure the total ampere rating of the 
devices plugged into the extension cord does not exceed the cord’s ampere rating. Also, 
make sure the total ampere rating of all devices plugged into the wall outlet does not 
exceed the wall outlet’s ampere rating.

■

Keep your printer and computer system away from potential sources of electromagnetic 
interference, such as loudspeakers or cordless telephone base units.

■

Avoid locations that are subject to rapid changes in heat or humidity, shocks or 
vibrations, or dust.

■

Leave enough room around the printer for sufficient ventilation.

■

Do not place the printer near a radiator or heating vent or in direct sunlight.

■

Place the printer on a flat, stable surface that extends beyond the printer base in all 
directions. The printer will not operate properly if it is tilted or at an angle.

■

Turn off and unplug the printer before cleaning. Clean with a damp cloth only. Do not 
spill liquid on the printer.

Always turn the printer off using the 

 

Ppower button. The 

 

Ppower light 

flashes briefly and then goes out. Don’t switch off the power strip, or unplug 
the printer until the 

 

Ppower light is off.

■

Do not block or cover the openings in the printer’s case or insert objects through the 
slots.

■

Except as specifically explained in this manual, do not attempt to service the printer 
yourself.

■

Unplug the printer and refer servicing to qualified service personnel under the following 
conditions:
If the power cord or plug is damaged; if liquid has entered the printer; if the printer has 
been dropped or the case damaged; if the printer does not operate normally or exhibits a 
distinct change in performance. Adjust only those controls that are covered by the 
operating instructions.