Epson 25 사용자 설명서
Problem Solving
51
Problems with External Video Equipment
No picture appears on the screen.
■
Make sure the equipment is turned on.
■
Press the
Power
button on MovieMate or on the remote control.
■
Press the
or
Play
button on the external equipment.
■
Make sure you don’t have cables connected to both the S-video and Video ports. You can
only use one connection at a time (see pages 35 and 36).
only use one connection at a time (see pages 35 and 36).
You see the message
No Signal
.
■
Make sure the equipment is turned on.
■
■
Press the
button on MovieMate or the remote control to select the external video
source. Allow a few seconds for MovieMate to sync up.
You see the message
Signal not supported.
Press the
button on the remote control and check the
Video Signal
setting (see
The picture is cut off (too large) or too small.
Press the
button on the remote control and select the appropriate aspect ratio.
The picture is distorted.
■
If you’re using an extension cable, electrical interference may affect the signal.
■
The colors are not right.
■
Press the
button on the remote control and check the
Video Signal
setting (see
■
Press the
button on the remote control to select the best setting for your viewing
environment.
■
Adjust the
Color Saturation
or
Tint
settings. See page 33.
MovieMate25UG.book Page 51 Wednesday, January 25, 2006 11:37 AM