Epson 7800p 사용자 설명서

Displaying and Adjusting the Image

Shutting Down the Projector

When you’ve finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.

1. Turn off and disconnect any equipment plugged into the

projector.

2. To turn off the projector, press the red P

Power

button on the

projector or remote control.

You see a confirmation message. (If you don’t want to turn it off,
press any other button.)

3. Press the

Power

button again. The power light flashes orange for

about 30 seconds as the projector cools down. After the projector
has cooled, the orange light stays on and the exhaust fan shuts off.

If you want to turn the projector on again, wait until the orange
light stops flashing. Then press the

Power

button.

4. If you extended the adjustable front foot, press up on the blue

foot release lever to retract it.

5. Replace the lens cap and unplug the power cord.

6. If you’re using a remote control, set its on/off switch to

OFF

. This

conserves battery power.

note

When the projector has not
received any input signals
for 30 minutes, it
automatically turns off the
projector lamp and enters
“sleep mode.” This conserves
electricity, cools the
projector, and extends the
life of the lamp. If you want
to start projecting again,
press the

Power

button. If

you are done using the
projector, unplug the power
cord. To turn off sleep mode,
see page 74.

Power button

Power OFF?

Yes

Yes :

: Press button

Press button

No :

: Press any other button

Press any other button

caution

To avoid damaging the
projector or lamp, never
unplug the power cord when
the power light is green or
flashing orange.