Epson 77C 제품 데이터시트
Epson PowerLite S5 Series / 77c Projector
5/07
Epson PowerLite S5 Series / 77c Projector
-
13
3. If you need to replace the filter, slide it out, as shown.
4. Align the new filter carefully and slide it in until it clicks
into place.
Note:
Air filters contain polycarbonate, ABS resin, and polyurethane
foam. Dispose of used air filters according to local regulations.
Air filters contain polycarbonate, ABS resin, and polyurethane
foam. Dispose of used air filters according to local regulations.
Replacing the Lamp
The projection lamp typically lasts for about 3000 hours of use
(in high brightness mode) or 4000 hours (in low brightness
mode). It is time to replace the lamp when:
❏ The projected image gets darker or starts to deteriorate.
❏ The lamp light is flashing orange.
❏ The message
(in high brightness mode) or 4000 hours (in low brightness
mode). It is time to replace the lamp when:
❏ The projected image gets darker or starts to deteriorate.
❏ The lamp light is flashing orange.
❏ The message
Replace the Lamp
appears on the screen
when the lamp comes on. To maintain projector brightness
and image quality, replace the lamp as soon as possible.
and image quality, replace the lamp as soon as possible.
Note:
You can check to see how many hours the lamp has been used
through the Info menu.
You can check to see how many hours the lamp has been used
through the Info menu.
Contact your dealer or call Epson at (800) 463-7766 for a
replacement lamp. Request part number V13H010L41.
replacement lamp. Request part number V13H010L41.
Warning:
Let the lamp cool before replacing it. If the lamp breaks, handle the
shards carefully to avoid injury.
Let the lamp cool before replacing it. If the lamp breaks, handle the
shards carefully to avoid injury.
Follow these steps to replace the lamp:
1. Press the P
Power
button twice to turn off the projector.
When you hear the projector beep twice, unplug the power
cord.
cord.
2. If the projector has been on, allow it to cool down for at
least an hour (or until the lamp is cool).
3. Use the screwdriver included with the replacement lamp to
loosen the screw holding the lamp cover (the lamp cover is
located on top of the projector).
located on top of the projector).
4. Slide the cover out, then lift it off.
5. Use the screwdriver to loosen the two screws holding the
lamp in place. (You can’t remove the screws.)
6. Hold the lamp as shown and pull it straight out.
Note:
The lamp(s) in this product contain mercury. Please
consult your state and local regulations regarding disposal or
recycling. Do not put in the trash.
recycling. Do not put in the trash.
Don’t remove
these screws
these screws