Epson 830p 매뉴얼

■

Make sure that you’ve connected the projector to the network and 
configured it correctly; see page 80. Also, make sure you’ve 
registered the projector with EMP Monitor; see page 81.

■

Make sure that Standby Mode in the projector’s Extended menu 
is set to 

Network ON

.

■

If the computer you are using is running Windows XP or 2000, 
you must be logged in as the Administrator.

■

Try restarting your computer.

■

Be sure the 

ON/OFF

 switch is in the 

ON

 position, as shown on 

■

The remote control’s batteries may not be installed correctly or 
may be low on power. To change the batteries, see page 33. 

■

Make sure your remote control’s ID is set to 0 or to the 
projector’s ID; see page 73.

■

Make sure you are within about 33 feet (10 meters) of the 
projector and within range of the projector’s front or back sensor 
(approximately 20° to the left or right and 40° above or below).

■

Dim the room lights and turn off any fluorescent lights. Make 
sure the projector is not in direct sunlight. Strong lighting, 
especially fluorescent lights, may affect the projector’s infrared 
receivers. Also, turn off any nearby equipment that emits infrared 
energy, such as a radiant room heater.