Epson 830p 매뉴얼

다운로드
페이지 148
32
Using the Remote Control
Turning On and Using the Remote 
Control
The remote control has an 
ON/OFF
 switch on its side, as shown. 
Before using the remote, make sure batteries are installed as described 
on page 33, then slide the 
ON/OFF
 switch to turn it on. 
Turn off the remote control before transporting or storing it; this 
prevents the batteries from discharging if something presses against 
one of the buttons. 
Here are some additional tips: 
Point the remote control at the front or back of the projector, or 
at the screen.
Stand within 33 feet of the projector. If you want to operate the 
projector from a greater distance, a remote control cable set is 
available (see page 13).
When presenting in a darkened room, press the 
light button to 
make the buttons on the remote light up temporarily. 
Avoid using the remote under bright fluorescent lamps or in 
direct sunlight, or the projector may not respond properly.
ON/OFF switch
note
If a button is pressed longer 
than 60 seconds, the remote 
control stops operating to 
conserve power. When you 
release the button, normal 
operation resumes.