Epson Cinema 200 사용자 설명서

■

Make sure the power cord is connected, then wait a moment for the P power light to 
turn orange before pressing the 

Power

 button.

■

If you’ve set the 

Key Lock

, the control panel buttons are disabled; you must use the 

remote control to turn on the projector (see page 25).

■

If you’ve set the 

Child Lock

, use the remote control or press and hold the 

Power

 button 

on the projector for at least 3 seconds to turn it on (see page 25).

 No Signal

■

Press the 

Source

 button on the projector or one of the 

Source

 buttons on the remote 

control to select the correct input source. Allow a few seconds for the projector to sync up 
after pressing the button.

■

Press the 

Blank

 button on the remote control to make sure the picture hasn’t been turned 

off temporarily.

■

Check that the P power light is green, not flashing, and the lens cover is off.

■

The projector may be in standby (or sleep) mode. If the P power light is orange, press the 

Power

 button to turn the projector back on. 

■

Make sure your video equipment is turned on.

■

Make sure your cable(s) are connected correctly (see page 15).

If you’re using a PC:

■

Press the function key that lets you display on an external monitor. It’s often labeled with 
an icon such as 

, but it may also be labeled 

CRT/LCD

. You may have to hold down 

the 

Fn

 key while pressing it. Check your laptop’s manual or online help.

On most systems, the 

 key lets you toggle between the LCD screen and the 

projector, or display on both at the same time. Allow a few seconds for the projector to 
sync up after pressing it.

■

If the function key doesn’t let you display simultaneously on both screens, you might 
need to use the Display utility in the Control Panel to make sure that both the LCD 
screen and external monitor port are enabled. From the Control Panel, open the 

Display