Epson Cinema 500 사용자 설명서

Adjusting the Image Quality

If the image looks fuzzy, or if it contains noise or flickering, you can use these settings to 
correct it.

■

Sharpness

Use this function to make lines and edges appear more distinct in the image.

■

Progressive

Leave this setting on 

Film/Auto

 so the projector automatically senses the type of image 

and displays it in the optimal mode. When receiving an interlaced image (in 480i or 575i 
format), the projector converts it to progressive. The projector uses DCDi (Directional 
Correlational Deinterlacing) for video-sourced images. For film-sourced images, the 
projector uses 3-2 pulldown detection and optimizes the image accordingly. 

You can adjust the projector’s sensitivity to still or moving images using the Motion 
Detection setting, described below.

If you notice the projected image switching between film and video mode, change the 
setting to 

Video

. If you’re viewing still images (such as computer graphics or digital 

camera photos) or pausing a video, you may want to switch to 

Off

 to prevent 

interlaced-to-progressive (IP) conversion from taking place.

Note: This setting applies only when viewing component video and the input signal is in 480i or 
575i format (see page 69).

■

Motion Detection

This setting works with the Progressive setting (described above). If you notice that 
moving images seem jittery or halting, or diagonal lines appear jagged, move the slider bar 
toward 

M

 (for motion). To increase detail for still images, move the slider bar toward 

S

 

(for still).

■

Noise Reduction

Leave this setting off, unless viewing images from a weak signal with a lot of noise. Turn 
the setting on and select one of the noise reduction options to suppress interference and 
makes images appear softer (available only if the image source is set to Video or S-Video).

Image

! Picture Quality ! Sharpness

Setting

! Advanced ! Progressive

Setting

! Advanced ! Motion Detection

Setting

! Advanced ! Noise Reduction