Epson Cinema 500 사용자 설명서

Setting Up Your Computer

Follow these steps to connect to your projector using a network cable:

1. Connect to the projector using a commercially available 10baseT or 100baseTX network 

cable (Category 5 or better).

Note: If you’ll be connecting the cable directly to the computer running Cinema Color Editor, 
use a “crossover” network cable. To connect to an access point on the network, such as a hub 
or router, use a standard “straight-through” cable.

2. Connect the other end of the cable to your computer or network access point, as desired.

3. Turn on the projector.

4. Press the 

Menu

 button on the remote control, then access the projector’s network 

settings (

Setting

!

Operation

!

Network

). 

5. Do one of the following:

■

Select 

DHCP

 if your computer or network assigns addresses automatically using 

DHCP.

■

Otherwise, turn off DHCP and use the arrow buttons on the remote control to enter 
the projector’s IP address. The first three parts of the address should be the same as 
for the computer running Cinema Color Editor; the last part should be a unique 
number. Use 255.255.255.0 as the subnet mask. When done entering an address, 
press the 

button to confirm it.

6. If you want to be able to turn on the projector from Cinema Color Editor, enable 

Network Monitoring

 (see page 38).

7. Turn the projector off and back on so the new settings take effect. 

To computer or 
network access point