Epson G5000 사용자 설명서

■

If the projector doesn’t turn on when you press the Ppower 
button, make sure the power cord is connected to the projector 
and plugged into a working electrical outlet.

■

The power cord may be defective. Disconnect the cord from the 
outlet and contact Epson as described on page 93.

■

If the Direct Power On function is enabled and you immediately 
plug the power cord back in after unplugging it, the power may 
not turn back on. Press the Ppower button to turn the projector 
back on.

If the Control Panel Lock function has been enabled, you can’t use the 
buttons on the projector. Try using the remote control instead (make 
sure it is set to the correct ID). See page 58 for information about the 
Control Panel Lock function.

■

Check that the Ppower light is green, not flashing. 

■

The projector may be in standby or sleep mode. If the Ppower 
light is orange, press the Ppower button to turn the projector on.

■

If the power was switched off and then on again, the projector 
may be cooling down. Wait until the Ppower light stops flashing 
and remains orange; then press the Ppower button again.

■

Press the 

A/V Mute 

button on the remote control to make sure 

the picture has not been turned off temporarily.