Epson G5000 사용자 설명서

■

Point the remote control towards the receiver.

■

Make sure the projector and remote control IDs match. To 
operate all projectors by remote control regardless of ID settings, 
set the ID switch on the side of the remote control to 

Off

.

■

The remote control’s batteries may not be installed correctly or 
may be low on power. To change the batteries, see page 78. 

■

Make sure you are within about 49 feet (15 meters) of the 
projector and within range of the projector’s front or back sensor.

■

Dim the room lights and turn off any fluorescent lights. Make 
sure the projector is not in direct sunlight. Strong lighting, 
especially fluorescent lights, may affect the projector’s infrared 
receivers. Also, turn off any nearby equipment that emits infrared 
energy, such as a radiant room heater. If necessary, use the 

Remote Receiver

 setting to disable the projector’s front or back 

■

Make sure the 

Remote Receiver

 setting isn’t disabling both of 

■

If any buttons are held for longer than 30 seconds, the remote 
enters sleep mode. Release any button that is held to wake the 
remote.

■

When the optional remote control cable is connected, the remote 
control light-emitting area and the projector’s remote receiver are 
disabled. If you’re not using the cable, make sure it is 
disconnected from both the remote control and the projector.