Epson cinema 550 제품 데이터시트
Epson PowerLite Cinema 550
4 - Epson PowerLite Cinema 550
11/05
Cable Connections
You can connect up to five pieces of video equipment to the
projector, using the ports listed below (cables are not included):
projector, using the ports listed below (cables are not included):
For best results, connect your video equipment to the
HDMI (High-Definition Multimedia Interface) port. If your
equipment doesn’t support HDMI, connect it to one of the
following ports (highest quality listed first): Input A (for
component video), S-Video, or Video (composite video).
HDMI (High-Definition Multimedia Interface) port. If your
equipment doesn’t support HDMI, connect it to one of the
following ports (highest quality listed first): Input A (for
component video), S-Video, or Video (composite video).
Making Other Connections
Depending on how you plan to use the projector, you may need
to connect these additional cables:
to connect these additional cables:
❏ Control (RS-232C)
Connect a computer or AV controller to this port.
❏ Trigger out port
This port outputs a 12-volt DC signal when the projector is
turned on, and can be used to raise or lower a projection
screen automatically.
turned on, and can be used to raise or lower a projection
screen automatically.
❏ Connect a 3.5-mm mini jack to the port, as shown.
Source
change
change
Terminal
Signal name
Input A
Input A
SOURCE 10
YCbCr
SOURCE 14
YPbPr
SOURCE 15
Auto
SOURCE 1F
Input B
Input B
SOURCE 20
RGB
SOURCE 21
Input 3
(HDMI)
(HDMI)
HDMI
SOURCE 30
Video Cycles
within
SOURCE 4X
SOURCE 40
Video (RCA)
SOURCE 41
S-Video
SOURCE 42
Input 5
D4
SOURCE C0
YCbCr
SOURCE C4
YPbPr
SOURCE C5
Auto
SOURCE CF
Color Mode
sRGB
CMODE 01
Theatre
CMODE 05
Living Room
CMODE 06
Natural
CMODE 07
Dynamic
CMODE 08
Theatre Black 1
CMODE 09
Theatre Black 2
CMODE 0A
Aspect ratio
Auto
ASPECT 00
Normal
ASPECT 20
Squeeze
ASPECT 21
Zoom
ASPECT 22
Through
ASPECT 23
Squeeze
Through
Through
ASPECT 24
Wide
ASPECT 25
Item
Command
Port
Required Cable
Supported video formats
Video
RCA video cable
Analog TV (NTSC, PAL, SECAM)
S-Video
S-video cable
Analog TV (NTSC, PAL, SECAM)
Input A
Use a 3-connector
component video cable.
Select YCbCr (NTSC) or
YPbPr (HDTV) as the
Input Signal setting (see
page 6)
component video cable.
Select YCbCr (NTSC) or
YPbPr (HDTV) as the
Input Signal setting (see
page 6)
Digital TV (SDTV and HDTV)
Analog TV (NTSC, PAL, SECAM)
Analog TV (NTSC, PAL, SECAM)
Input B
Mini D-sub, 15-pin
monitor cable
monitor cable
RGB
HDMI
HDMI cable
Digital TV (SDTV and HDTV)