Epson GT-15000 사용자 설명서

Getting Started

In order to use the SCSI connection, you need to make sure your computer has a 
SCSI board and any necessary SCSI software installed. Then follow these steps to 
connect the scanner:

1. Make sure the scanner is off.

2. If you have another SCSI device that 

uses SCSI ID 2, turn the SCSI ID 
switch on the back of the scanner to a 
new number. Do not use 0, 1, or 7.

3. Unless your scanner is connected in 

the middle of a SCSI chain, leave the 
terminator switch on the back of the 
scanner turned 

On

.

4. Squeeze the lock releases on your 

SCSI cable, and plug it into either 
SCSI connector on the back of the 
scanner. Connect the other end of 
the cable to the SCSI port on your 
computer.