GoVideo d645 제품 매뉴얼

다운로드
페이지 24
22
Handling Precautions
•  Hold the disc by the edges so 
the surface will not be soiled with 
fi ngerprints.
•  Fingerprints, dirt and scratches can 
cause skipping and distortion.
•  Do not write on the label side with a 
ball-point pen or other writing utensil.
•  Do not use record cleaning sprays, 
benzine, thinner, static electricity 
prevention liquids, or any other 
solvent.
•  Be careful not to drop or bend the 
disc.
•  Do not install more than one disc on 
the disc tray.
•  Do not try to close the disc tray when 
the disc is not installed properly. 
•  Be sure to store the disc in its original 
case when not in use.
If the surface is soiled
•  Wipe gently with a soft, damp (water 
only) cloth.
•  When wiping discs, always move the 
cloth from the center hole toward the outer edge. (If you 
wipe the disc using a circular motion, circular scratches 
are likely to occur, which will cause noise.)
If the disc is brought from a cold to a warm 
environment, moisture may form on the disc
•  Wipe moisture off with a soft, dry, lint-free cloth before 
using the disc.
Improper disc storage
You can damage discs if you store them in the following 
places:
•  Areas exposed to direct sunlight
•  Humid or dusty areas
•  Areas directly exposed to a heat outlet or heating 
appliance
Disc which cannot be played with this player
•  CD-ROM (Application Program)
•  CVD
•  CD-G
•  DVD with a Region Code other than that shown on the 
DVD unit’s Region Code Label on the rear panel
Maintenance
•  Be sure to turn the unit off and disconnect the AC power 
cord before maintenancing the unit.
•  Wipe the unit with a dry soft cloth. If the surfaces are 
extremely dirty, wipe clean with a cloth that has been 
dipped in a weak soap-and-water solution and wrung out 
thoroughly, and then wipe again with a dry cloth.
•  Never use alcohol, benzine, thinner, cleaning fl uid or 
other chemicals. And do not use compressed air to 
remove dust.
Disc Handling & Maintenance
Disc Handling & Maintenance
Power cord protection
To avoid any malfunctions of the unit, and to protect against 
electric shock, fi re or personal injury, please observe the 
following:
•  Hold the plug fi rmly when connecting or disconnecting 
the AC power cord.
•  Keep the AC power cord away from heating appliances.
•  Never put any heavy object on the AC power cord.
•  Do not attempt to repair or reconstruct the AC power 
cord in any way.
Placement
Avoid placing the unit in areas of:
•  Direct sunlight or heating radiators, or closed 
automobiles
•  High temperature (over 95°F) or high humidity (over 
90%)
•  Signifi cant dust as the internal parts may be seriously 
damaged.
Non-use periods
•  When the unit is not being used, turn it off. When left 
unused for a long period of time, the unit should be 
unplugged from the household AC outlet.
No fi ngers or other objects inside
•  Touching internal parts of this unit is dangerous, and 
may cause serious damage to the unit. Do not attempt to 
disassemble the unit.
•  Do not put any foreign object in the disc tray.
Keep away from water
•  Keep the unit away from fl ower vases, tubs, sinks, etc. 
If liquids are spilled into the unit, serious damage could 
occur.
Keep away from magnets
•  Never bring a magnet or magnetized object near the unit.
Stacking
•  Place the unit in a horizontal position, and do not place 
anything heavy on it.
Condensation
Moisture may form on the lens in the following conditions:
•  Immediately after a heater has been turned on
•  In a steamy or very humid room
•  When the unit is suddenly moved from a cold 
environment to a warm one
If moisture forms inside this unit, it may not operate properly. 
In this case, turn on the power and wait about one hour for 
the moisture to evaporate.
If there is noise interference on the TV while 
a broadcast is being received
•  Depending on the reception condition of the TV, 
interference may appear on the TV monitor while you 
watch a TV broadcast and the unit is left on. This is 
not a malfunction of the unit or the TV. To watch a TV 
broadcast, turn off the unit.