GoVideo dvr4400 사용자 설명서

DVR4400 DVD+VCR

Timer Recording Errors

Tape Missing

Insert a VHS tape in the VCR deck.

Tape Missing Tab

Insert a VHS tape with a record safety tab.

Deck Not Ready

The tape in the VCR deck is already in use. Select the

VCR deck, then press STOP

Overlapping Events

If two events overlap, you will be prompted to

delete one of the events, or allow them to overlap. If you allow them to over-

lap, the event with the earliest starting time will be completely recorded,

then the remainder of the event with the next earliest starting time will be

recorded.

Event List Full

Press ENTER to view the list of events. Select an event

to delete, and then press CLEAR.

Event in the Past

If you try to create an event that is in the past, you

will receive an error message. However if the event started in the past, but

has not ended yet, the deck will begin recording immediately.

Complete Program Record (CPR)

Complete Program Record (CPR) automatically adjusts the recording speed so

you don’t run out of tape before the recording is complete. When Record Speed is set to Auto, the DVD+VCR will begin recording

in SP. It will then calculate how much time is remaining on the tape and adjust the record speed to SLP if necessary. If there is not

enough room to record the entire show, the DVD+VCR will record in SLP until the end of the tape is reached.

• The Timer indicator will light when an event is programmed. If

there is an error, the Timer indicator will blink (see Timer

Recording Errors below).

• To delete an event, use

and

to select it, then press

CLEAR.