KYOCERA fs-1128 설치 설명서
Accessing COMMAND CENTER
SETUP GUIDE
17
3
Click Submit.
E-mail Settings
The following procedure explains the method for attaching scan data to e-mail for
transmission. Scan to e-mail works within the following environments:
transmission. Scan to e-mail works within the following environments:
•
It must have a network environment in which this machine can connect to a
mail server. It is recommended that the machine be used in an environment in
which it can connect to the mail server at any time over a LAN.
mail server. It is recommended that the machine be used in an environment in
which it can connect to the mail server at any time over a LAN.
•
The SMTP settings must be completed. Use COMMAND CENTER, to register
the IP address and the host name of the SMTP server.
the IP address and the host name of the SMTP server.
•
There may be a times where transmission is not possible due to the size of
each e-mail item.
each e-mail item.
The scanner system network component offers e-mail function. SMTP is an
embedded protocol to support this function. To use the e-mail function, the scanner
system needs connection to an e-mail server using the POP3 protocol.
embedded protocol to support this function. To use the e-mail function, the scanner
system needs connection to an e-mail server using the POP3 protocol.
IPv4 Settings
DHCP/BOOTP
DHCP/BOOTP
Specifies whether or not to automatically obtain an IP address using DHCP or
BOOTP.
BOOTP.
IP Address (IPv4)
Assigns the Internet Protocol address on the printing system network component.
The format of the IP address is four-byte (32-bit) numbers separated by dots, e.g.
192.168.110.171.
The format of the IP address is four-byte (32-bit) numbers separated by dots, e.g.
192.168.110.171.
Subnet Mask
Specifies the subnet mask of the hosts or network with which the print system is
connecting. If you have manually assigned an IP address that starts with a number
between 192 and 223, it is recommended that you set the subnet mask to
"255.255.255.0."
connecting. If you have manually assigned an IP address that starts with a number
between 192 and 223, it is recommended that you set the subnet mask to
"255.255.255.0."
Default Gateway
Specifies the IP address of the default gateway.
IPv6 Settings
IPv6
IPv6
Specifies whether or not to enable the IPv6 protocol. Select On to use the IPv6
protocol.
protocol.
IP Address (IPv6)
Assigns an IPv6 address to the printing system network component. The format of
the IPv6 address is a sequence of numbers (128 bit in total) separated by colons,
e.g. 2001:db8:3c4d:15::1a2c:1a1f.
the IPv6 address is a sequence of numbers (128 bit in total) separated by colons,
e.g. 2001:db8:3c4d:15::1a2c:1a1f.
Prefix Length
Specifies the IPv6 prefix length of the hosts or network with which the print system
is connecting.
is connecting.
RA (Stateless)
Select On to use RA to configure IPv6 addresses.
Default Gateway
Specifies the IPv6 address of the default gateway.
DHCPv6
Specifies whether or not to obtain IPv6 IP addresses by automatic configuration.
When RA is turned On, the IP addresses and server information are obtained via
DHCPv6 based on the settings of the automatic configuration made under RA
(router setting).
When RA is turned On, the IP addresses and server information are obtained via
DHCPv6 based on the settings of the automatic configuration made under RA
(router setting).
Item
Description