LG DLE2301W 사용자 매뉴얼

24

Your dryer features FlowSense

™

, an innovative 

sensor system that automatically detects 

blockages and restrictions in dryer ductwork. 

Keeping ductwork clean of lint build-up and free 

of restrictions allows clothes to dry faster and 

reduces energy use.
NOTE: When the dryer is first installed, this test 

should be performed to alert you to any existing 

problems with the exhaust duct in your home.

However, since the test performed during normal 

operation provides more accurate information on 

the condition of the exhaust duct than does the 

installation test, the number of bars displayed 
during the two tests may not be the same.

NOTE: Dryer heating test must be performed 

before proceeding. (Gas dryer only)

Then perform the duct condition test below.

Press and hold the DAMP DRY BEEP and 

TEMP CONTROL buttons at the same time. 

While holding these buttons, press POWER 

ON/OFF.

 

The dryer will show lnS in the number display 

to indicate that it is in duct condition testing 

mode.
Press START/PAUSE. The dryer will run for 

approximately 2 minutes to test 

for blockages or restrictions to air 

flow in the ductwork. 

If no bars are shown in the display, 

the ductwork is free from blockages 

or restrictions. 

If all bars are lit, the dryer ductwork 

has a blockage that needs to be 

removed immediately. 

IMPORTANT: Do NOT interrrupt the test cycle!

Avoid long runs or runs with multiple elbows 

or bends.

Check for blockages and lint buildup.

Make sure the ductwork is not crushed  

or restricted.