Sony FST-ZUX9 매뉴얼

One of the following messages may 
appear or flash in the display during 
operation.

There is no disc on the disc tray.

You cannot record onto the tape because 
the tab has been removed from the tape.

There is no tape in the tape deck.

You have pressed a button those operation 
is not allowed or invalid at that time.

The on time and off time of Play Timer or 
Recording Timer is the same.

PUSH SELECT!
You tried to set the clock or timer during 
timer operation.

You have pressed PLAY MODE on the 
remote during playback.

The system is reading information of the 
disc. Some buttons are not available.

You have cleared all the steps you 
programmed.

You have reached the end of the disc 
while pressing M during playback or 
pause.

You tried to program more than 25 steps.

You pressed CLOCK/TIMER SELECT 
on the remote before the clock is set.

You pressed CLOCK/TIMER SELECT 
on the remote before Play Timer or 
Recording Timer is set.

The system is reading information of the 
USB device. Some buttons are not 
available.

You tried to play back an MP3 audio track 
that is not playable (page 49).

The USB device could not be recognized 
or an unknown device is connected.

The USB

device was removed during 

recording or erasing operation, and may 
have been damaged.

All of the programmed tracks have been 
erased.

An unsupported USB device is connected 
or the USB device is connected through 
an USB

hub.

No playable MP3 audio track is loaded in 
the system.

You tried to perform a specific operation 
under conditions where that operation is 
prohibited.

An over current was detected.