Sony MZ-R500 매뉴얼

There is no 
recording on the 
MD after a 
recording 
operation.

• The AC power adaptor was unplugged or a power outage occurred 

during recording.

The lid does not 
open.

• The battery have been exhausted.

, Replace the exhausted battery with new ones.

Volume cannot be 
turned up.

• AVLS is on.

, Set AVLS to “OFF” (page 22).

No sound comes 
through the 
headphones/
earphones.

• The headphones/earphones plug is not firmly connected.

, Plug in the plug of the headphones/earphones firmly to i.

• Volume is too low.

, Adjust the volume by pressing VOL +/–.

An MD is not 
played from the 
first track.

• Disc playing stopped before it came to the last track.

, Press . repeatedly or open and close the lid once to go back 

to the beginning of the disc, and restart playing after checking 
the track number in the display.

Playback sound 
skips.

• The recorder is placed where it receives continuous vibration.

, Put the recorder on a stable place.

• A very short track may cause sound to skip.

Sound has a lot of 
static.

• Strong magnetism from a television or such device is interfering 

with operation.
, Move the recorder away from the source of strong magnetism.

Cannot find the 
track marks.

• You pressed X after pressing . or >.

, Press X before or pressing . or > (page 27).

The disc cannot 
edit on other 
component.

• The component does not support LP2 and LP4.

, Edit on other component that support LP2 and LP4.

Momentary noise 
is heard.

• Due to the special digital audio compression technology used in 

LP4 mode, momentary noise may occur on very rare occasions 
with certain sound sources.
, Record in normal stereo or LP2 mode.