Sony HCD-HPX9 매뉴얼
O
p
ti
on
al
al
C
o
o
mp
on
en
ts
en
ts
masterpage:Right
filename[\\Nas-data-server\SONY Current jobs\SONY CMT-HPX10W-HPX9-
HPX7\DTP\4255291112\425529111CMTHPX10WCEL\GB10OPT-CEL.fm]
HPX7\DTP\4255291112\425529111CMTHPX10WCEL\GB10OPT-CEL.fm]
25
GB
model name[CMT-HPX10W/CMT-HPX9/CMT-HPX7]
[4-255-291-11(2)]
Placing the transmitter
Placing it up off the floor, such as on a desk, is
recommended.
The transmitter has a signal reception area of 1
to 46 m. However, this distance may be reduced
depending on the surroundings and
environment, such as obstacles (wall, etc.).
recommended.
The transmitter has a signal reception area of 1
to 46 m. However, this distance may be reduced
depending on the surroundings and
environment, such as obstacles (wall, etc.).
Notes
• Do not place the transmitter on or near the following
objects. Doing so may cause noise.
– Main unit, TV, speaker, fluorescent lamp, floor.
– Radio waves generated such as cell phones and
cordless phone systems or metal instruments are
placed on the unit.
placed on the unit.
– Inside a building with walls containing steel
beams.
– Area with many steel file cabinets, etc.
– Area with many electrical appliances capable of
generating electromagnetic noise.
– Area facing roadways.
– Radio transceivers in trucks, etc.
– Wireless communication systems installed along
roadways.
• Even within the signal reception area, there are some
spots (dead spot) where the RF signal cannot be
received. This is a characteristic inherent to RF
signals, and does not indicate a malfunction. By
slightly moving the transmitter, the location of the
dead spot can be changed.
received. This is a characteristic inherent to RF
signals, and does not indicate a malfunction. By
slightly moving the transmitter, the location of the
dead spot can be changed.
Listening to audio using a
wireless system
wireless system
1
Start playing the connected
component.
component.
2
Press FUNCTION repeatedly to switch
the function to WIRELESS.
the function to WIRELESS.
3
Press +/– (or TUNING +/– on the unit).
“AUTO SCAN” appears.
“AUTO SCAN” appears.
If the system picks up some
noise or “AUTO SCAN” does not
disappear
noise or “AUTO SCAN” does not
disappear
• Reduce the distance between the transmitter
unit and the main unit.
• Select another channel using CHANNEL 1–3
on the transmitter, then press +/– (or
TUNING +/– on the unit). “AUTO SCAN”
appears.
TUNING +/– on the unit). “AUTO SCAN”
appears.
Notes
• You may not hear the beginning of the sound from
the main unit until the transmitter starts sending the
RF signals after detecting an audio signal.
RF signals after detecting an audio signal.
• If the transmitter is connected to the headphones jack
of the source component, set the volume of that
component as high as possible without distorting the
audio signal.
component as high as possible without distorting the
audio signal.
• If you hold the antenna of the transmitter with your
hand, noise may occur. However this is not a
malfunction.
malfunction.
• When the transmitter is not to be used for a long
period of time, disconnect the AC power adaptor
from the wall outlet holding the plug. Do not pull on
the cord.
from the wall outlet holding the plug. Do not pull on
the cord.