Nikon D1 사용자 설명서

This section describes the steps involved in using a SB-28DX  Speedlight for
3D multi-sensor balanced fill-flash photography.

After attaching the Speedlight, choose any metering method other than
spot.

Choose an exposure mode and confirm shutter speed and aperture.

Choose a flash sync mode as described above under “Flash Sync Modes.”

Turn the Speedlight power switch to ON or
STBY, and set the Speedlight mode to

.

  will appear in the Speedlight dis-

play.

Compose a picture, lightly press the shutter-
release button, and check focus and flash
charge in the viewfinder display.

After checking the flash range in the
Speedlight display, press the shutter-release
button all the way down to take a picture.

Notes

Flash Photography: Using a Speedlight

In shutter-priority auto and manual exposure modes, shutter speed can be set to a
value between 

1

/

500

 sec. and thirty seconds.  If speed faster than 

1

/

500

 sec. is chosen,

the camera will automatically lower shutter speed to 

1

/

500

 sec.

When using slow sync or slow sync with red-eye reduction, set the exposure mode to
programmed auto or aperture-priority auto.

If the flash-ready indicator blinks for about three seconds after a photograph is taken
with a flash set to TTL or external automatic mode, the photograph may be underex-
posed.  Check the photograph in the LCD monitor.  If it is underexposed, adjust the
focus distance, aperture, or flash range and try again.

Read all instructions in the Speedlight manual thoroughly.