Canon LV-7590 지침 매뉴얼

다운로드
페이지 90
4
 
Safety Precaution
WARNING:  ● THIS APPARATUS MUST BE EARTHED .
 
  TO REDUCE THE RISK OF FIRE OR 
ELECTRIC SHOCK, DO NOT EXPOSE THIS 
APPLIANCE TO RAIN OR MOISTURE .
–  This  projector  produces  intense  light  from  the  projection 
lens.  Do  not  stare  directly  into  the  lens,  otherwise  eye 
damage could result. Be especially careful that children do 
not stare directly into the beam.
–  Install the projector in a proper position. Otherwise it may 
result in a fire hazard.
–  Allowing  the  proper  amount  of  space  on  the  top,  sides, 
and  rear  of  the  projector  cabinet  is  critical  for  proper  air 
circulation  and  cooling  of  the  unit. The  diagrams  shown 
here indicates the minimum space required. If the projector 
is  to  be  built  into  a  compartment  or  similarly  enclosed, 
these minimum distances  must be maintained.
1.5' (50 cm)
1.5' (50 cm)
1.5' (50 cm)
3' (1 m)
SIDE and TOP
REAR
–  Do  not  cover  the  ventilation  slots  on  the  projector.  Heat 
build-up  can  reduce  the  service  life  of  your  projector,  and 
can also be dangerous.
–  If the projector is unused for an extended time, unplug the 
projector from the power outlet.
–  Do  not  project  the  same  image  for  a  long  time. 
The  afterimage  may  remain  on  the  LCD  panels  by  the 
characteristic of panel.
 
CAUTION ON HANGING FROM THE CEILING
When  hanging  the  projector  from  the 
ceiling,  clean  the  air  intake  vents  and  top 
of the projector periodically with a vacuum 
cleaner.  If  you  leave  the  projector  unclean 
for  a  long  time,  the  cooling  fans  can  be 
clogged  with  dust,  and  it  may  cause  a 
breakdown or a disaster.
DO  NOT  SET  THE  PROjECTOR  IN  GREASy,  WET, 
OR  SMOKy  CONDITIONS  SUCH  AS  IN  A  KITCHEN 
TO  PREVENT  A  BREAKDOWN  OR  A  DISASTER .  IF 
THE  PROjECTOR  COMES  IN  CONTACT WITH  OIL  OR 
CHEMICALS, IT MAy BECOME DETERIORATED .
To The Owner
CAUTION:TO REDUCE THE RISK OF ELECTRIC 
SHOCK, DO NOT REMOVE COVER 
(OR BACK) . NO USER-SERVICEABLE 
PARTS INSIDE EXCEPT LAMP 
REPLACEMENT .  REFER SERVICING TO 
QUALIFIED SERVICE PERSONNEL .
THIS SYMBOL INDICATES THAT DANGEROUS 
VOLTAGE CONSTITUTING A RISK OF 
ELECTRIC SHOCK IS PRESENT WITHIN THIS 
UNIT.
THIS SYMBOL INDICATES THAT THERE 
ARE IMPORTANT OPERATING AND 
MAINTENANCE INSTRUCTIONS IN THE 
USER’S MANUAL WITH THIS UNIT.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Before installing and operating the projector, read this 
manual thoroughly.
The projector provides many convenient features and 
functions. Operating the projector properly enables 
you to manage those features and maintains it in good 
condition for many years to come.
Improper operation may result in not only shortening the 
product life, but also malfunctions, fire hazard, or other 
accidents.
If your projector seems to operate improperly, read this 
manual again, check operations and cable connections 
and try the solutions in the “Troubleshooting” section 
in the back of this manual. If the problem still persists, 
contact the dealer where you purchased the projector or 
the service center.
READ AND KEEP THIS USER’S MANUAL FOR LATER USE .
CAUTION
Not for use in a computer room as defined in the 
Standard for the Protection of Electronic Computer/
Data Processing Equipment, ANSI/NFPA 75.
NOTE FOR CUSTOMERS IN THE US
Hg  LAMP(S)  INSIDE THIS  PRODUCT  CONTAIN  MERCURY 
AND MUST BE RECYCLED OR DISPOSED OF ACCORDING TO 
LOCAL, STATE OR FEDERAL LAWS.