Canon LE-5W WH 지침 매뉴얼

59

Menu function settings

Home screen > Setup > Basic > Key Lock

This function locks the control panel and 
remote control buttons during standby to 
prevent the projector from being turned on 
accidentally. 

•  To turn on the projector when Key Lock is 

on, press and hold the INPUT button on 
the control panel or the AUTO PC button 
on the remote control until the STATUS 
LED lights up briefly. You can then turn on 
the projector by pressing the POWER 
button on the control panel or the remote 
control.

•  If you press any buttons other than the 

INPUT button on the control panel or the 
AUTO PC button on the remote control 
while the keys are locked, the STATUS 
LED lights up (

).

Home screen > Setup > Basic > 
Auto Keystone 

This function automatically detects the 
projector's angle of tilt and adjusts keystone 
distortion to project the optimum image. 

 

•  Keystone can be adjusted within ± 40 

degrees. (When projecting an input signal 
with 3D timing, the keystone can only be 
adjusted within ± 4 degrees.)

• Because 

digital 

processing is performed 

when adjusting the image, the image after 
adjustment may differ from the original 
image. Also, the screen's aspect ratio may 
change.

•  If you perform manual keystone 

adjustment from the OSD, the auto 
keystone function is disabled until the next 
time the projector is started. However, you 
can enable auto keystone again by setting 
Auto Keystone to Off, and then setting it 
back to On.

Start the projector as normal.

If you do not release the key 
lock, you cannot turn on the 
projector. 

See the note below for more 
details.

Auto Keystone is not 
performed.

Auto Keystone is performed.