Canon REALiS WUX400ST D Pro AV 매뉴얼
Replacing the Lamp
202
Replacement Lamp
This projector uses the following lamps.
Lamp part no.: RS-LP08
Contact the Canon Customer Support Center when purchasing a replacement
lamp.
lamp.
Replacing the Lamp
1
Turn off the projector power and remove the power plug.
2
Press the lamp cover release button to release the lock.
Precautions when replacing lamps that stop working
If the illumination suddenly stops when the projector is in use or after
you turn it on, the lamp may be broken. In this case, never attempt to
replace the lamp by yourself. Always request service from the Canon
Customer Support Center. Additionally, with ceiling-mounted
projectors, the lamp may fall out when you open the lamp cover or
while you are attempting to replace it. During replacement, stand to the
side of the lamp cover, not directly under it. If the lamp breaks and any
glass shards or other pieces get in your eyes or mouth, consult a
doctor immediately.
If the illumination suddenly stops when the projector is in use or after
you turn it on, the lamp may be broken. In this case, never attempt to
replace the lamp by yourself. Always request service from the Canon
Customer Support Center. Additionally, with ceiling-mounted
projectors, the lamp may fall out when you open the lamp cover or
while you are attempting to replace it. During replacement, stand to the
side of the lamp cover, not directly under it. If the lamp breaks and any
glass shards or other pieces get in your eyes or mouth, consult a
doctor immediately.
When replacing the lamp, turn off the projector, wait until the cooling
fan stops, disconnect the power plug from the electrical outlet, and let
the projector stand for at least 1 hour. Otherwise, you may get burned
because the main unit is very hot immediately after the projector is
turned off.
fan stops, disconnect the power plug from the electrical outlet, and let
the projector stand for at least 1 hour. Otherwise, you may get burned
because the main unit is very hot immediately after the projector is
turned off.
• Be sure to use the specified lamp.
• Contact the Canon Customer Support Center for further information.
• Contact the Canon Customer Support Center for further information.
This can also be purchased from the Canon website.
• Do not touch the inner glass surface when you replace the lamp.
Doing so may cause deterioration to the projector’s performance.
• Handle lamps with care. Impact or abrasion may cause lamps to
rupture while they are in use. If a lamp ruptures, contact the Canon
Customer Support Center and follow the instructions in
“Precautions when replacing lamps that stop working” (
Customer Support Center and follow the instructions in
“Precautions when replacing lamps that stop working” (
• When replacing the lamp, do not remove any screws other than
those specified.