Canon LV-7490 브로셔
LV-7490 Expand Serial Command Functional Specifications
31
8.7.3 CF_VSCALE
Command
Command “CF_VSCALE_%1”[CR]
%1
“032” --------- +32
“031” --------- +31
:
“031” --------- +31
:
“002” --------- +2
“001” --------- +1
“000” --------- +0
“-01” ---------- -1
“-02” ---------- -2
:
“001” --------- +1
“000” --------- +0
“-01” ---------- -1
“-02” ---------- -2
:
“-31” ---------- -31
“-32” ---------- -32
“UP” ---------- Vertical Scale setting value + 1
“DN” ---------- Vertical Scale setting value - 1
“-32” ---------- -32
“UP” ---------- Vertical Scale setting value + 1
“DN” ---------- Vertical Scale setting value - 1
Details
Set Vertical Scale
This command is available in normal Power ON status.
Note1) When Aspect setting is not in Custom mode, projector changes image
mode into Custom by receiving this command.
Note2) When there is no signal detected, projector returns 101 and the command
does not execute.
This command is available in normal Power ON status.
Note1) When Aspect setting is not in Custom mode, projector changes image
mode into Custom by receiving this command.
Note2) When there is no signal detected, projector returns 101 and the command
does not execute.
Response
Acceptable “000”[CR]
Unacceptable “Error
Code”[CR]
8.7.4
CF_VPOS
Command
Command “CF_VPOS_%1”[CR]
%1
“015” --------- +15
“014” --------- +14
:
“014” --------- +14
:
“002” --------- +2
“001” --------- +1
“000” --------- +0
“-01” ---------- -1
“-02” ---------- -2
:
“001” --------- +1
“000” --------- +0
“-01” ---------- -1
“-02” ---------- -2
:
“-14” ---------- -14
“-15” ---------- -15
“UP” ---------- Vertical Position setting value + 1
“DN” ---------- Vertical Position setting value – 1
“-15” ---------- -15
“UP” ---------- Vertical Position setting value + 1
“DN” ---------- Vertical Position setting value – 1
Details
Set Vertical Position
This command is available in normal Power ON status.
Note1) When Aspect setting is not in Custom mode, projector changes image
mode into Custom by receiving this command.
Note2) When there is no signal detected, projector returns 101 and the command
does not execute..
This command is available in normal Power ON status.
Note1) When Aspect setting is not in Custom mode, projector changes image
mode into Custom by receiving this command.
Note2) When there is no signal detected, projector returns 101 and the command
does not execute..
Response
Acceptable “000”[CR]
Unacceptable “Error
Code”[CR]