ASUS H97-PLUS 사용자 설명서

1-8

Chapter 1: Product introduction

This motherboard comes with four Double Data Rate 3 (DDR3) Dual Inline Memory Module

(DIMM) sockets. The figure illustrates the location of the DDR3 DIMM sockets:

Channel A

DIMM_A1 and DIMM_A2

Channel B

DIMM_B1 and DIMM_B2

You may install 2GB, 4GB, and 8GB unbuffered non-ECC DDR3 DIMMs into the DIMM

sockets.

•

You may install varying memory sizes in Channel A and Channel B. The system

maps the total size of the lower-sized channel for the dual-channel configuration. Any

excess memory from the higher-sized channel is then mapped for single-channel

operation.

•

According to Intel CPU spec, DIMM voltage below 1.65V is recommended to protect

the CPU.

•

Always install DIMMs with the same CAS latency. For optimal compatibility, we

recommend that you install memory modules of the same version or date code (D/C)

from the same vendor. Check with the retailer to get the correct memory modules.

•

Due to the memory address limitation on 32-bit Windows

®

OS, when you install 4GB

or more memory on the motherboard, the actual usable memory for the OS can be

about 3GB or less. For effective use of memory, we recommend that you do any of the

following:

- 

Use a maximum of 3GB system memory if you are using a 32-bit Windows

®

OS.

-

Install a 64-bit Windows

®

OS if you want to install 4GB or more on the

motherboard.

-

For more details, refer to the Microsoft

®

 support site at http://support.microsoft.

com/kb/929605/en-us. 

•

This motherboard does not support DIMMs made up of 512Mb (64MB) chips or less

(Memory chip capacity counts in Megabit, 8 Megabit/Mb = 1 Megabyte/MB).

DIMM_A1 DIMM_A2

DIMM_B1 DIMM_B2