ASUS ESC2000 Personal SuperComputer 사용자 설명서

6-4

Chapter 6: RAID configuration

3.  The utility main window appears. Use the arrow keys to select an option from 

the 

Management Menu and then press <Enter>. Refer to the Management 

Menu descriptions on the next page.

 

At the bottom of the screen is the legend box. The keys on the legend box 

allow you to navigate through the setup menu options or execute commands. 

The keys on the legend box vary according to the menu level.

The LSI MegaRAID software RAID configuration utility allows you to create RAID 0, 

RAID 1, or RAID 10 set(s) from SATA hard disk drives connected to the SATA 

connectors supported by the motherboard southbridge chip.
To enter the LSI MegaRAID software RAID configuration utility

1.  Turn on the system after installing all the SATA hard disk drives.
2.  During POST, the LSI MegaRAID software RAID configuration utility 

automatically detects the installed SATA hard disk drives and displays any 

existing RAID set(s). Press <Ctrl> + <M> to enter the utility.

•  The LSI MegaRAID software RAID configuration utility automatically 

configures to RAID 1 when the SATA to RAID Mode is enabled.

•  The RAID setup screens shown in this section are for reference only and 

may not exactly match the items on your screen due to the controller 

version difference.

•  When you create RAID sets with the LSI MegaRAID software RAID 

configuration utility, the boot priority of the SATA optical drive has to be 

manually adjusted. Otherwise, the system will not boot from the connected 

SATA ODD.