ASUS ASMB4-iKVM 사용자 설명서

ASUS ASMB4-iKVM/ASMB4-SOL PLUS

2-13

Before you can establish connection to the ASMB4-iKVM/ASMB4-SOL PLUS 

board, you must configure the LAN port for server management used by the 

remote server to connect to the local/central server.
To configure the LAN port of the remote server:
1.  Run the ASMC4 utility from the support CD following the instructions in the 

previous section.

2.  Set IP source:
 

(a)  Type asmc4 -bmc_ip_source 1 if you want to set a static IP address.

 

(b)  Type asmc4 -bmc_ip_source 2 if you want to get IP from DHCP server.

3.  Type asmc4 -bmc_ip xxx.xxx.xxx.xxx, then press <Enter> to assign any IP 

address to the remote server LAN port (if necessary). The screen displays the 

request and response buffer. Write the remote server IP address in a piece of 

paper for reference.

 

When finished, the utility returns to the DOS prompt.

Make sure that the assigned IP address for both remote and local/central 

servers are in the same subnet. You can use the network settings utility in your 

OS to check.

4.  Configure your (a) subnet mask and (b) gateway address if necessary.

(a)  Type asmc4 -bmc_mask xxx.xxx.xxx.xxx (your subnet mask encoded in 

hexadecimal system)

(b)  Type asmc4 -bmc_gateway xxx.xxx.xxx.xxx (your gateway address 

encoded in hexadecimal system)

5.  Restart the remote server, enter the BIOS setup, then boot from the hard disk 

drive.

6.  Adjust the local/central server network settings, if necessary.