ASUS VivoMini UN45 설치 가이드

2

3

4

5

6

•

It is recommended that you install or upgrade the memory modules, wireless

card, and solid state drive (SSD), under professional supervision. Visit an ASUS

service center for further assistance.

•

Ensure that your hands are dry before proceeding with the rest of the installation

process. Before installing any of the features in this guide, use a grounded wrist

strap or touch a safely grounded object or metal object to avoid damaging them

due to static electricity.

Your VivoMini comes with the following items. Please contact ASUS Service Center if you cannot

find the following items:
•

4 pcs holed rubber foot

•

2 pcs 2mm round screws, 1 hexagon screw

•

4 pcs 3mm round screws, 4 pcs 2mm round screws (on selected models)

•

2 pcs HDD bracket (on selected models)

•

1 pc HDD cable (on selected models)

15060-64610000

3.

Remove the four screws securing the cover.

1.

Turn off your VivoMini then disconnect all cables and peripherals.

2.

Place the VivoMini on a flat stable surface, with its top side facing down.

Your VivoMini comes with two SO-DIMM memory slots that allow you to install two 2GB, 4GB,

or 8GB unbuffered with non-ECC 1.35 V DDR3L 204-pin SO-DIMMs for a maximum of 16GB

memory.

IMPORTANT! Refer to http://www.asus.com for the list of compatible DIMMs. You can

only install 1.35 V DDR3L SO-DIMM to the VivoMini’s DIMM slots.

•

The CPU model N3000 only has one DIMM slot.

•

Some models may only support up to a maximum of 8GB memory

NOTE: The illustrations in this guide are for reference only. The slots may vary

depending on model.

4.

Get one screw from the ones you previously removed then place it into the hole. Leave

a portion of the screw head that would be enough for you to hold.

5.

Hold the screw then gently pull out the cover from the bottom side of the VivoMini. Use

your other free hand to hold the VivoMini in place.

7.

Remove the screw you previously attached on the bottom cover.

6.

Align and insert the memory module into the slot (A) and press it down (B) until it is

securely seated in place. Repeat the same steps to install the other memory module.

IMPORTANT! Always install into the upper slot first.

NOTE: The CPU model N3000 only has one DIMM slot.

8.

Place the cover back on the bottom side of your VivoMini. Note that the cover can only

be inserted in one direction. Refer to the following illustration and note to ensure that

the cover is securely fitted on the bottom side of the VivoMini.

IMPORTANT! The rating label area (A) and the power button’s location (B) must be

oriented as shown.

9.

Reattach the screws to secure the cover back on the bottom side of the main box.

10.

Place the rubber foot on each screw hole. Refer to the illustration for more details.

IMPORTANT! A number is printed under each rubber foot and this number

corresponds to that rubber foot’s location on the cover. Follow the orientation of each

rubber foot and the number sequence shown in the illustration below. The rubber

foot fits in only one orientation. Note the position of the hole on each rubber foot, as

shown in the illustration below

NOTE: If you want to remove the rubber foot, use a flathead screwdriver or a

straightened paper clip to do so.

E10670_VivoMini_Memory_SSD_WiFi_installation_V3_fold.indd   1-6

2015/10/21   �� 04:55:10