Epson Руководство по установке устройства настенного крепления модели ELPMB23 설치 가이드
11
English
4 Extension Pipe
To adjust the height of where the projector is installed, you need to purchase a
separate extension pipe. There are two extension pipe model numbers, ELPFP13 and
ELPFP14. The illustration below shows the range of distances between ceiling plate
and projector to which each model can be adjusted.
separate extension pipe. There are two extension pipe model numbers, ELPFP13 and
ELPFP14. The illustration below shows the range of distances between ceiling plate
and projector to which each model can be adjusted.
5 For Safe Use
• Only a specialist should remove or install the projector, including for maintenance
and repairs.
See the instruction manual of the projector for information about maintenance and
repairs.
See the instruction manual of the projector for information about maintenance and
repairs.
6 Inquiries
• For further inquiries, our contact details are given in the instruction manual of the
projector.
Ceiling plate
Extension pipe
Projector plate
ELPFP13: 668 mm to 918 mm
(50 mm pitch)
ELPFP14: 918 mm to 1168 mm
(50 mm pitch)
(50 mm pitch)
ELPFP14: 918 mm to 1168 mm
(50 mm pitch)
Never loosen any bolts, screws or nuts after installation. Also check
periodically that no screws have come loose. If you find a loose
screw, retighten it firmly.
screw, retighten it firmly.
Do not swing from the ceiling mount. Doing so could cause the
projector and ceiling mount to fall and injure someone.
Warning