Epson Сетевое руководство 네트워크 가이드

After connecting the printer to the network, you need to set the IP address for the network interface.

To set the IP address, subnet mask, and default gateway from the control panel, follow the steps
below.

1. Turn on your printer.

2. Press the Enter button on the printer’s control panel once to enter the SelecType mode. The

LCD panel displays Information Menu.

3. Press the Up or Down button until Network Menu appears. Then press the Enter button.

4. Check that Network I/F = On appears.

If Network I/F = Off appears instead, press the Enter button and then the Up or Down
button to change to Network I/F = On. Then press the Enter button, turn off the printer for
more than five seconds, and turn it back on.

5. Press the Up or Down button until Get IP Address = Auto appears. Press the Enter

button and then the Up or Down button to change to Get IP Address = Panel. Then press
the Enter button. You can use the following methods to get an IP address.

❏ Choose Panel when setting the IP address, subnet mask, and default gateway using the

printer’s control panel.

❏ Choose Auto when getting the IP address from a DHCP server. The IP address is

automatically obtained from the DHCP server whenever the printer is reset or turned on.

❏ Choose PING when setting the IP address using the arp/ping command. The network

interface uses the IP address set by the arp/ping command. The settings become available
when the printer is reset or turned off and then back on.

EPSON     Network Guide

Tips for Administrator     121