Epson Сетевое руководство 네트워크 가이드
Large format inkjet printers (Models that support 1000 Mbps communication)
Status light
Data light
Network Status
Red
Yellow
Ready (100 M link)
Red
Yellow (Flashing)
Receiving packets (100 M link)
Green
Yellow
Ready (1000 M link)
Green
Yellow (Flashing)
Receiving packets (1000 M link)
Network connector
RJ-45 connector: This connector is used to connect an Ethernet cable to a network. You can use this
cable for 10Base-T, 100Base-TX, and 1000Base-T Ethernet.
cable for 10Base-T, 100Base-TX, and 1000Base-T Ethernet.
c
Important:
You must use the following shielded twisted-pair cable to connect the network interface to a
network.
You must use the following shielded twisted-pair cable to connect the network interface to a
network.
❏ Category-5 or higher for the 10Base-T or 100Base-TX connection
❏ Category-5e or higher for the 1000Base-T connection
About the Software
The Software Disc provided with your printer includes the following network software.
Note:
The software provided varies depending on your printer model.
The software provided varies depending on your printer model.
❏ EpsonNet Config for Windows is a Windows-based configuration utility for administrators that
allows you to configure the network interface for various protocols such as TCP/IP, MS Network,
AppleTalk, IPP, and SNMP. See “EpsonNet Config for Windows” on page 48.
AppleTalk, IPP, and SNMP. See “EpsonNet Config for Windows” on page 48.
❏ EpsonNet Config for Macintosh is a Macintosh-based configuration utility for administrators
that allows you to configure the network interface for TCP/IP, AppleTalk, and IPP. See “EpsonNet
Config for Macintosh” on page 50.
Config for Macintosh” on page 50.
Epson Network Guide
Introduction 12