Epson Сетевое руководство 네트워크 가이드
The message “EpsonNet Config cannot be used because no network is
installed.” appears when you start EpsonNet Config.
installed.” appears when you start EpsonNet Config.
Cause
What to do
Both TCP/IP and IPX/SPX are not installed on
the computer.
the computer.
Install the TCP/IP or IPX/SPX protocol.
TCP/IP is installed on the computer, but its IP
address is not set correctly.
address is not set correctly.
Set a correct IP address for the computer.
The message “Could not complete communicating configuration data”
appears when you send settings to the network interface.
appears when you send settings to the network interface.
Cause
What to do
This may happen when using a dial-up
router.
router.
Run Command Prompt from the computer on which EpsonNet Config
is installed, and then enter the following command:
is installed, and then enter the following command:
Format: >ROUTE_ADD_the IP address of the network interface_ the IP
address of the computer (the under bar represents one space)
address of the computer (the under bar represents one space)
Example: >ROUTE ADD 192.168.192.168 22.33.44.55.
Unable to start EpsonNet Config with Web Browser.
Cause
What to do
You have not set the IP address for the
network interface.
network interface.
Set the IP address for the network interface using EpsonNet Config for
Windows or Macintosh, the printer’s control panel. You can check the IP
address on a status sheet. See the EpsonNet Config User’s Guide.
Windows or Macintosh, the printer’s control panel. You can check the IP
address on a status sheet. See the EpsonNet Config User’s Guide.
Epson Network Guide
Troubleshooting 75