Canon imagePROGRAF iPF785 MFP M40 매뉴얼

If you are printing on sheets smaller than A2 size for Auto(OtherPaper), a confirmation message is shown on
the Display Screen requesting you to continue printing.
Press the OK button and follow the instructions on the Display Screen.

If printed images are affected by banding in different colors, execute Adj. Quality for adjustment of the paper feed
amount.
Use Manual adjustment with highly transparent media or other paper for which Auto(GenuinePpr) or Auto(OtherPa-
per) cannot be used.

Manual adjustment requires you to enter an adjustment value after a test pattern is printed.

Note

Use paper of the same type and size for adjustment as you will use for printing.

Always check the Adj. Priority values before using Manual adjustment.

If additional fine-tuning is necessary after Manual adjustment, use Adj. Fine Feed

Use Adjust Length to ensure that lines in CAD drawings are printed at exactly the right length.

Paper to Prepare

When Using Rolls

An unused roll at least 10 inches wide

When Using Sheets Two sheets of unused paper of at least A4/Letter size

Perform adjustment as follows.

Load the paper.

Important

Always make sure the loaded paper matches the type of paper specified. Adjustment cannot be completed
correctly unless the loaded paper matches the settings.

 

On the Tab Selection screen of the Control Panel, press 

◀ or ▶ to se-

lect the Settings/Adj. tab (

).

Note

If the Tab Selection screen is not displayed, press the Menu button.

Press the OK button.
The Set./Adj. Menu is displayed.

Press ▲ or ▼ to select Adjust Printer, and then press the OK button.

Press ▲ or ▼ to select Feed Priority, and then press the OK button.

 

Manual Banding Adjustment

                                                                                                                                                                                           

iPF785

                                                                                                                                                                                                                             

Adjustments for Better Print Quality

Adjusting the feed amount

 

582