Canon VB-M641V 매뉴얼
Admin Viewer/VB Viewer
5
167
[Registered] will appear in [Day Mode:].
[Clear the registered focus position?] will appear if you select [Use One-shot AF]
or [None], even if only one focus position has been registered for either [Day Mode] or [Night Mode].
If you select [No], the registered focus position will be retained even if you select to [Use One-shot AF] or [None].
Note
See the following for the focus ranges when using Day/Night Mode settings.
– “Focus Ranges” (P. 161)
– The table in the “Note” section of “Set the Focus” (P. 55)
– The table in the “Note” section of “Set the Focus” (P. 55)
Infrared
Set how infrared illumination is used.
(1)
[Day/Night Operation]
Linked to Day/Night. Turns on infrared illumination in Night Mode.
(2)
[Do not use]
Infrared illumination is not used.
(3)
Infrared Illumination Strength
Sets the infrared illumination strength when [Day/Night Operation] is selected.
Note
If all or part of the image appears to have a white glow, there is a possibility that a wall (even a wall not in the image) is reflecting the infra-
red lighting. If this occurs, please adjust the camera angle.
red lighting. If this occurs, please adjust the camera angle.
External Device Output
Use external device output.
Click the icons to activate and deactivate output.
Output status is shown by the icons.
Screen Example:
Output 1: inactive
Output 2: active
3
Under the lighting conditions of the Day Mode, adjust the focus position as required while watching the video.
4
Click [Register focus position] in the [Day/Night Mode Focus Settings] panel.
5
Switch Day/Night Mode to [Night Mode].
6
Repeat steps 3 and 4 under the Night Mode lighting conditions to register the focus position.
R11
R10
M641 M640 M741 M740
Important
Infrared illumination strength can only be set when [Exposure] (P. 162) is set to [Manual].
M741
(3)
(2)
(1)
R11 M641 M741