Canon imagePROGRAF iPF510 매뉴얼
Handling rolls
Cutting the Leading Edge of Roll Paper Automatically
If the leading edge of a roll is crooked or warped, it may cause an error message or printing problems. In this
case, set Trim Edge First to Automatic or On on the Control Panel to have the printer cut the leading edge to
make the edge straight after you load a roll.
case, set Trim Edge First to Automatic or On on the Control Panel to have the printer cut the leading edge to
make the edge straight after you load a roll.
Trim Edge First offers the following options.
•
Automatic
If the left and right side of the leading edge of the roll ((a) and (b)) are uneven by 3 mm (0.12 in) or more
when you load the roll, the edge is cut an amount relative to the slant to ensure a straight edge, and
scraps are removed. The edge is not cut if the unevenness is less than 3 mm.
when you load the roll, the edge is cut an amount relative to the slant to ensure a straight edge, and
scraps are removed. The edge is not cut if the unevenness is less than 3 mm.
•
Off
The edge is not cut and scraps are not removed. This setting is Off for most types of paper, by default.
For more information, see the Paper Reference Guide. (→P.103)
For more information, see the Paper Reference Guide. (→P.103)
•
On
The leading edge is cut off when you load a roll, and scraps are removed. The amount of paper cut
off from the leading edge varies depending on the paper type. For more information, see the Paper
Reference Guide. (→P.103)
off from the leading edge varies depending on the paper type. For more information, see the Paper
Reference Guide. (→P.103)
Note
•
If you print on paper that has an irregular width, set Skew Check Lv. to Loose for a higher skew
detection threshold or to Off to disable skew detection. However, if paper is loaded askew when
detection is Off, note that paper jams or Platen soiling may occur.
Follow these steps to change the Trim Edge First setting.
1.
Press the Menu button to display MAIN MENU.
2.
Press ◄ or ► to select Med.Detail Set., and then press ▼.
MAIN MENU
Med.Detail Set. ↓
Med.Detail Set. ↓
3.
Press ◄ or ► to select the type of paper, and then press the ▼ button.
Med.Detail Set.
= Plain Paper ↓
= Plain Paper ↓
Handling Paper 135