Canon XA35 매뉴얼

Recording Audio

89

Low Cut Filter (MIC Terminal)

When you are recording using a microphone connected to the MIC terminal, you can activate the low 
cut filter to reduce the sound of blowing wind, a car’s engine and similar ambient sounds. 

1 Open the [MIC Low Cut] screen.

[FUNC.] 

>

 [MENU] 

>

 p 

>

 [MIC Low Cut]

2 Touch  [i On] and then touch [X].

Using Line Input or an External Microphone Connected to an INPUT 
Terminal

Follow the steps below to use an external microphone 
connected to an INPUT terminal.

1 Set the INPUT terminal ON/OFF switch to ON.

2 Set the sensitivity switches for INPUT 1/INPUT 2 to LINE 

or MIC.

• To supply a microphone with phantom power, set the 

switch to MIC+48V instead. Make sure to connect the 
microphone first, before turning the phantom power on. 
Keep the microphone connected when turning off the 
phantom power.

Recording Audio to Channel 2 (CH2)

You can select the audio source that will be recorded to channel 2.

1 Open the [CH2 Input] screen.

[FUNC.] > [MENU] > p > [CH2 Input]

2 Touch the desired option and then touch [X].

Options

(



 Default value)

Operating modes:

[

INPUT  1]

The audio signal input through the INPUT 1 terminal will be recorded to channel 1 

and channel 2. You can use this setting when recording audio for backup purposes.

[

INPUT  2]

The audio signal input through the INPUT 2 terminal will be recorded to channel 2 

while the audio signal input through the INPUT 1 terminal will be recorded to channel 1.

[

Built-in  Mic/MIC]

The audio captured by the built-in microphone or audio signal input through 

the MIC terminal will be recorded to channel 2 while the audio signal input through the INPUT 1 
terminal will be recorded to channel 1. You can use this setting when recording audio for backup 
purposes.