Canon Océ VarioPrint 6000+ Series 매뉴얼
Operator Manual
Page 63
4.8.9 Book output mode:
Before being directed on to the conveyor, the book can be realigned by the cover clamps and
the stop before being output.
4 modes for the output of the book on to the conveyor are possible:
In this mode, the book falls on the clamps and on the stop before being output on the
conveyor. This mode is the "AUTO" mode for book thickness of 15 to 60 mm.
In this mode, the book falls on the stop before being output on the conveyor.
In this mode, the book falls on the clamps before being output on the conveyor.
In this mode, the book is output directly to the conveyor. The book is therefore not
realigned before being output on the conveyor. This mode is the "AUTO" mode for
book thickness of 0 to 15 mm.
Note: In padding mode, only output modes
2
and
4
are possible.
Mode 1, 2 or 3 may decrease productivity and may affect the performance of the
upstream device in online mode.
4.8.10 Configuring front and back glue cut-offs:
This button enables you to stop the application of glue at the front and back of the book's spine.
The button changes according to whether the glue cut-offs occur on or beyond the spine.
• In this case, the glue cut-offs are set to
5 mm - 0.2" from the edges of the book.
The arrows
and
modify this value.
Maximum value: 130 mm - 5.1".
Default value: 15 mm - 0.6".
• If the operator reduces the value below
0, the glue cut-offs will be beyond the edges of the
book. Glue will therefore be applied to the whole spine of the book.
Example: In this case, the glue cut-off will be 10 mm - 0.4" from the edges of the
book.
Maximum value: 60 mm - 2.36".
1.
2.
3.
4.