Canon CINE-SERVO 17-120mm T2.95-3.9 PL 매뉴얼
E28
3. Operation in Basic Mode
3.1.3 Specifying Auto Iris Gain
[IG]
Although this value is factory-set, it can be adjusted as needed.
To adjust the value, use either the auto iris gain adjustment trimmer (refer to the Lens Manual) or display operations.
Regardless of the method of adjustment used, the most recent setting takes precedence.
The same auto iris gain value applies to all users.
To adjust the value, use either the auto iris gain adjustment trimmer (refer to the Lens Manual) or display operations.
Regardless of the method of adjustment used, the most recent setting takes precedence.
The same auto iris gain value applies to all users.
Options
01
to
99
Description
Minimum gain
Maximum gain
Default: Varies depending on the factory-set value, but corresponds to the value determined with the iris gain adjustment trimmer.
MENU
IG
or
MENU
IG: 50
IG: 50
IG: 50
IG: 50
IG: 51
IG: 51
[Trk]OFF
Shtl
A 1
A 2
A 2
MENU
IG: 50
A
Fr1P
Fr1P
[I-Tq]H
[Adj]
[Trk]OFF
Shtl
A 1
A 2
A 2
A
Fr1P
Fr1P
[I-Tq]H
[Adj]
MENU
IG: 51
IG: 51
[Trk]OFF
Shtl
A 1
A 2
A 2
A
Fr1P
Fr1P
[I-Tq]H
[Adj]
Note: Do the following when
adjusting gain while checking
iris operation.
iris operation.
→ Confi rm that the drive unit A/M
switch is set to [Auto] mode.
→ Set the camera iris mode to
[Auto].
Note: As you look at the lens iris
ring, set it to the position of
maximum gain at which “focus
hunting” does not occur.
maximum gain at which “focus
hunting” does not occur.
Note: The current iris gain value
is retained even if you reset
other settings as described in
“3.2.1 Resetting Values.” For
this reason, you will no longer
be able to view the default
setting. If necessary, make
a note of the default setting
before adjusting this value.
other settings as described in
“3.2.1 Resetting Values.” For
this reason, you will no longer
be able to view the default
setting. If necessary, make
a note of the default setting
before adjusting this value.
1
2
3
4
Press
.
Your selection is now highlighted.
Press
.
The display starts blinking.
Press
or
.
Press left or right until you reach
the desired value.
the desired value.
Press
.
The display changes from blinking to
highlighted, indicating confi rmation.
highlighted, indicating confi rmation.
Initial Top Screen
Screen A