Canon REALiS 4K501ST Pro AV 매뉴얼
33
Before Use
Be
fo
fo
re
Us
e
e
Preparing the Remote Control
■ Installing Remote Control Batteries
• If buttons on the remote control are inoperative when you attempt to operate the
projector, replace the batteries with new ones.
• Do not drop the remote control or subject it to impact.
• Do not spill any liquids on the remote control. Doing so may cause a malfunction.
• Do not spill any liquids on the remote control. Doing so may cause a malfunction.
Pay attention to the following points when handling the batteries.
Failing to do so could result in a fire or personal injury.
• Do not heat, short circuit or disassemble the batteries, or place
Failing to do so could result in a fire or personal injury.
• Do not heat, short circuit or disassemble the batteries, or place
them in a fire.
• Do not attempt to recharge the batteries that are included with the
remote control.
• Remove the batteries when they are flat or when the remote control
will not be used for a long period of time.
• When replacing the batteries, replace both at the same time. Also,
do not use two batteries of a different type at the same time.
• Insert the batteries with the + and - terminals in the correct
directions.
• If any liquid from inside the batteries leaks out and contacts your
skin, be sure to wash the liquid off thoroughly.
(1)
(2)
3
Close the
compartment lid.
Insert the tab into the
remote control notch
(1) and push the
battery cover down
(2).
compartment lid.
Insert the tab into the
remote control notch
(1) and push the
battery cover down
(2).
2
Insert batteries.
Insert 2 new AA
batteries in the
compartment with the
+ and – terminals
positioned correctly.
Insert 2 new AA
batteries in the
compartment with the
+ and – terminals
positioned correctly.
1
Open the battery
compartment lid.
Raise the battery
cover tab while
pushing it.
compartment lid.
Raise the battery
cover tab while
pushing it.