Lenovo 43W4391 사용자 설명서
Chapter 3. Blade server hardware configuration
369
Only one PEU3e can be attached to the blade server. When a PEU3e is added to a blade
server along with the Storage I/O Expansion (SIO), only slot 1 of the PEU3e will be functional.
See 3.18, “Expansion blades” on page 358, for a discussion of all expansion units and the
supported combinations for each blade server type. Table 3-92 on page 358 lists the blade
servers that support the attachment of the PEU3e.
server along with the Storage I/O Expansion (SIO), only slot 1 of the PEU3e will be functional.
See 3.18, “Expansion blades” on page 358, for a discussion of all expansion units and the
supported combinations for each blade server type. Table 3-92 on page 358 lists the blade
servers that support the attachment of the PEU3e.
For the list of PCI Express adapters that are supported in the two full-length slots of the
PEU3e, see ServerProven at:
PEU3e, see ServerProven at:
http://www.ibm.com/servers/eserver/serverproven/compat/us/peu/43W4391.html
Figure 3-64 PCI Express I/O Expansion Unit (PEU3e)
There are no PCI-X or PCI Express sockets on the PEU3e that are suitable for BladeCenter
expansion cards such as the StFF, CFFh, or CFFv expansion cards. Therefore, if the PEU3e
is attached to a blade server, then it is not possible to also install a CFFh I/O adapter.
expansion cards such as the StFF, CFFh, or CFFv expansion cards. Therefore, if the PEU3e
is attached to a blade server, then it is not possible to also install a CFFh I/O adapter.
Figure 3-65 on page 370 shows the internal circuitry of the PEU3e.
Note: Using PCI Express adapters that require more than 25W requires special testing
and support to be completed. The cable or cables used to connect to the 12 volt
connectors on the PEU3e are only available if this testing is completed successfully.
Contact your IBM representative to engage the SPORE process.
and support to be completed. The cable or cables used to connect to the 12 volt
connectors on the PEU3e are only available if this testing is completed successfully.
Contact your IBM representative to engage the SPORE process.