Olympus UFL-3 지침 매뉴얼

다운로드
페이지 36
EN 21
EN
5. Using as TTL (auto-modulating) flash
When using the flash with a camera equipped with a wireless RC flash
function, it can be used as the TTL (auto-modulating) flash. The light
quantity of this flash can be controlled automatically by the setting of the
flash mode, correction of the light emission amount and so forth on the
camera. For information about the setting of the camera, refer to the
camera’s instruction manual.
Turning on the electronic flash
1
Turn the mode dial to set one of the RC A or RC B.
The flash turns on.
To turn off, turn the mode dial to set the OFF position.
The Ready/TTL lamp turns red when the charging is completed and the
flash emission is possible.
 CAUTION
• If it takes 30 seconds or more to reach the state that the flash emission is
possible after the power is turned on or the Ready/TTL lamp goes off,
replace batteries with new ones.
• The electronic flash automatically turns off when no operations are
performed for 30 minutes. Turn it on again.
UFL-3_EN.book  Page 21  Thursday, July 17, 2014  5:21 PM