Netgear M4300-28G (GSM4328S) - Stackable Managed Switch with 24x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 소프트웨어 가이드

This section describes the commands you use to configure IP Multicast and to view IP 
Multicast settings and statistics. 

This command adds an administrative scope multicast boundary specified by groupipaddr 
and mask for which this multicast administrative boundary is applicable. groupipaddr is a 
group IP address and mask is a group IP mask. This command can be used to configure a 
single interface or a range of interfaces.

This command deletes an administrative scope multicast boundary specified by 
groupipaddr

 and mask for which this multicast administrative boundary is applicable. 

 is a group IP address and mask is a group IP mask.

This command configures an IPv4 multicast static route for a source.

Format

ip mcast boundary groupipaddr mask

Mode

Interface Config

Format

no ip mcast boundary groupipaddr mask

Mode

Interface Config

Default

No MRoute is configured on the system.

Format

ip mroute src-ip-addr src-mask rpf-addr preference

Mode

Global Config

src-ip-addr

The IP address of the multicast source network.

src-mask

The IP mask of the multicast data source.

rpf-ip-addr

The IP address of the RPF next-hop router toward the source.

preference

The administrative distance for this Static MRoute, that is, the preference value. The range is 1 to 
255.