Netgear M5300-52G-POE+ (GSM7252PSv1h2) - ProSAFE 48+4 L2+ POE Stackable Managed Switch 관리자 가이드
264
|
Chapter 15. Security Management
ProSafe Managed Switch
Create a Static Address
The example is shown as CLI commands and as a Web interface procedure.
CLI: Create a Static Address
Web Interface: Create a Static Address
1.
Select Security > Traffic Control > Port Security > Static MAC address. A screen
similar to the following displays.
similar to the following displays.
2.
Under Port List, in the Interface list, select 1/0/1.
3.
In the Static MAC Address section of the screen, enter the following information:
•
In the Static MAC Address field, enter 00:13:00:01:02:03.
•
In the Vlan ID list, select 3.
4.
Click Add.
Protected Ports
This section describes how to set up protected ports on the switch. Some situations might
require that traffic is prevented from being forwarded between any ports at Layer 2 so that
one user cannot see the traffic of another user on the same switch. Protected ports can:
require that traffic is prevented from being forwarded between any ports at Layer 2 so that
one user cannot see the traffic of another user on the same switch. Protected ports can:
•
Prevent traffic from being forwarded between protected ports.
•
Allow traffic to be forwarded between a protected port and a non-protected port.
(Netgear Switch) (Interface 1/0/1)#port-security mac-address 00:13:00:01:02:03