Netgear JWNR2000v2 - Wireless-N 300 Router 사용자 설명서
Chapter 6. Advanced Settings
|
69
NETGEAR N300 Wireless Router JWNR2000v2 User Manual
LAN Setup
The LAN Setup screen allows configuration of LAN IP services such as DHCP and Routing
Information Protocol (RIP). The router is shipped preconfigured to use private IP addresses
on the LAN side and to act as a DHCP server. The router’s default LAN IP configuration is as
follows:
Information Protocol (RIP). The router is shipped preconfigured to use private IP addresses
on the LAN side and to act as a DHCP server. The router’s default LAN IP configuration is as
follows:
•
LAN IP address. 192.168.0.1
•
Subnet mask. 255.255.255.0
These addresses are part of the private address range designated by the Internet
Engineering Task Force (IETF
Engineering Task Force (IETF
http://www.ietf.org/
) for use in private networks, and should be
suitable in most applications. If your network has a requirement to use a different IP
addressing scheme, you can make those changes in the LAN IP Setup screen.
addressing scheme, you can make those changes in the LAN IP Setup screen.
Note:
If you change the LAN IP address of the router while connected
through the browser, you are disconnected. To reconnect, open a
new connection to the new IP address and log in.
new connection to the new IP address and log in.
To configure LAN settings:
1.
Select
Advanced > LAN Setup . The LAN Setup screen displays.
2.
Enter the configuration and click
Apply to save your changes.