Netgear ME101 – Wireless Ethernet Bridge 설치 가이드

Note: Before you begin, have your wireless network set up and working.

a. Unpack the box and verify the contents.

b. Place the bridge away from potential sources of interference, such 

as computers, monitors, TVs, microwaves, cordless phones, or 
large metal surfaces and in an elevated location such as a high shelf
or on a wall in the center of your wireless access area.

c. Lift the bridge’s antenna so it is vertical.

d. Turn off the gaming console(s) or other Ethernet-enabled device(s).

e. Connect the provided Ethernet cable between the ME101 Wireless 

Bridge and the gaming console or other Ethernet-enabled device.

f. Connect the power adapter to the wireless bridge and plug 

the power adapter in to a power outlet. The Power       and 
Wireless          lights should light up. 

g. After the Wireless light         lights up, turn on the Ethernet-enabled

device.

e. Connect the ME101 Wireless Bridge to a hub using the provided 

Ethernet cable. Then, connect the powered down game console(s) 
and the powered down Ethernet-enabled device(s) to the hub.

f. Connect the power adapters to the bridge and the hub. Plug the 

power adapters in to power outlets. The Power       and 
Wireless         lights should light up. 

g. After the Wireless light         lights up, turn on any game console(s) 

first. Then, turn on any other Ethernet-enabled devices.

For either setup, if the bridge and the Ethernet-enabled device(s) are
successfully connected, the Network light        will light up. This
light flashes when there is network activity.

Note: If your setup works with the default settings, you don’t need to
install the software from the provided CD to configure the bridge.

Note: To run the configuration utility, you must have the bridge 
connected to a computer with Windows

®

98, Me, 2000, or XP —

either directly or through a hub. If you have a Macintosh

®

computer,

please refer to the User’s Guide on the ME101 Resource CD for configu-
ration instructions.

a. Insert the ME101 Resource CD in a networked computer’s 

CD-ROM drive.

The NETGEAR software installation utility should start up 
automatically.

b. Click Install Utility.

c. Follow the instructions on screen to install the ME101 

Configuration Utility.

d. Click Finish.

e. Restart the computer.

Note: You may connect the computer to the bridge through a hub.

a. If you had the bridge powered up, unplug it.

b. Connect the provided Ethernet crossover cable between the 

computer and the bridge.

c. Plug the power adapter into the bridge and then plug the power 

adapter into a power source.

802.11b Wireless Ethernet Bridge ME101

Resource

 

CD for Wireless 

Ethernet Bridge, Installation guide, 
Support information card, 
Warranty card

Cat 5 crossover
Ethernet cable

ME101 Wireless Ethernet Bridge

Power adapter

ME101 Wireless 
Ethernet Bridge

Gaming console or other  
Ethernet-enabled device

ME101 Wireless 
Ethernet Bridge

10 BASE-T HUB

 EN104    Link                       Rx   

Normal / Uplink

PWR

COL

Wireless Router 
MR814

Cable  or 
DSL modem

ME101 Wireless 
Ethernet Bridge

EN104TP Ethernet Hub

Gaming console or other  
Ethernet-enabled device

PC